Removing Expansion Card Risers - Dell EMC VxRail P470 Owner's Manual

Figure 36. Installing the riser 1 blank
1 slot on the chassis
3 riser 1 blank
Next steps
1 Install the expansion card risers.
2 Follow the procedure listed in the After working inside your appliance section.

Removing expansion card risers

Prerequisites
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your appliance section.
3 If installed, remove any expansion card installed on risers 2 and 3.
NOTE: The expansion card riser 1 can be used only when both the processors are installed.
Steps
1 Holding the slots on the expansion card riser, lift the riser from the riser connector on the system board.
2 To remove expansion card risers 2 and 3, hold the edges of the expansion card riser, and lift the riser from the riser connector on the
system board.
NOTE: To ensure proper cooling, the riser 1 blank must be installed in the riser 1 slot. Remove the riser 1 blank only if
you are installing riser 1.
2 tab (2)
Installing and removing components 79