Removing Expansion Card Risers - Dell EMC PowerEdge R7415 Installation And Service Manual

Figure 69. Installing an expansion card on the system board
Next steps
1 Connect the required cables to the expansion card.
2 Install the air shroud.
3 If removed, install the rear drive
4 Follow the procedure listed in

Removing expansion card risers

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Disconnect any cables connected to the expansion card.
4 Remove the air shroud.
5 If installed, remove the rear drive
Step
Hold the touch points, and lift the expansion card riser, from the riser connector, on the system board.
112 Installing and removing system components
cage.
After working inside your system.
Safety instructions.
Before working inside your
cage.
system.