Table of Contents
Advertisement
11 Size of data block of response data
12 List of supported common commands
13 Condition of device when calibration is successfully completed
14 Maximum length of block data which can be used for definition of *DDT trigger macro
15 Maximum length of macro label used in definition of macro, maximum length of block data which can be used for
definition of macro, processing when recursion is used in definition of macro
16 Response to *IDN?
17 Size of storage area for protected user data for PUD and *PUD?
18 Length of *RDT and *RDT? resource name
19 Change in status due to *RST, *LRN?, *RCL and *SAV
20 Execution range of self-test using the *TST?
21 Structure of extended return status
22 To find out whether each command is performed in parallel or sequentially
23 Description of execution of each command
IM 760151-17E
1 to 308922 bytes
Refer to Section 5.20 "Common Command Group".
Same as the one under which measurements are performed
Not supported
Macro functions are not supported.
Refer to Section 5.20 "Common Command Group".
*PUD and *PUD? are not supported.
*RDT and *RDT? are not supported.
*RST
Refer to Section 5.20 "Common Command Group".
*LRN?, *RCL, *SAV
These commands are not supported.
All the memory tests (for each internal memory) given in the Self Test menu displayed
using the MISC can be executed.
Refer to Chapter 6.
Refer to Section 4.5 "Synchronization with the Controller" and to Chapter 5.
Refer to Chapter 5 of this manual and to the User's Manual IM 760151-01E.
Appendix 3 Overview of IEEE 488.2-1987
App
App-5
Advertisement
Table of Contents
