Software Configuration; Level 2 Configure Menu; Constants - Ametek 5000 Instrument Manual

The 5000 Analyzer is designed to be customized to suit user preferences by altering the software
configuration of the controller. The configure menus are used to alter numerous system parameters
and constants and assign flags to controller display, analog outputs, and alarms. To access the config-
ure menus, press the
TEST
password; refer to Page 3-1: System Security and Passwords for more information. Scroll down until
Configure Menu is highlighted; press
Different Configure Menus will be accessed depending on which password is entered at this time.

The Level 3 password should be entered only if troubleshooting is needed or access to critical
NOTE
configuration parameters is required. It is recommended that the Level 3 password be restricted to
knowledgeable and authorized personnel.

Level 2 Configure Menu

Figure 14 shows the sub-menus of the Configure Menu when the Level 2 password has been en-
tered. Scroll up, down, left, and right until desired menu item is highlighted; press
tinue.
Configure Menu
Dry_CF
Cell_SN
MoistGen_SN
Output1_Flag
Output2_Flag
Output3_Flag
Output4_Flag
Maint_Pswrd
Confg_Pswrd
Enter New Value
Enter New Value
Figure 14: Level 2 Configure Menu

SOFTWARE CONFIGURATION

/ key. At the "Enter Access Code" prompt, enter the Level 2 or Level 3
CONFIG
.
ENTER

Level 2

Constants

Analog
Passwords
Moist_Gen
Flags1
To Access:
Press TEST/CONFIG Key
Enter Level 2 Access Code
Highlight Configure Menu
Press Enter
Display
Timing
Serial
Noise
to con-
ENTER
Line_1_Flag
Line_2_Flag
Line_3_Flag
AutoCalCycle
Cal_Timer
Sample_Cycles
Equil_Cycles
Avg_Cycles
RS485_Baud
RS485_Address
Enter New Value
Software Configuration 4-1