Function Key Overview - Ametek 5000 Instrument Manual

Function Key Overview

All analyzer functions are configured through the 5000 Controller keypad shown in
Figure 11. Press one of the four function keys (
) to access the main menu for that category of sub-menus and system values.
CONFIG
Use the
system value lists. Enter values (which may be negative or contain a decimal point)
using the
Figure 11: 5000 Controller Keypad.
To select an item, scroll through the items until small arrowheads point to it on both
sides. Up and down arrow keys displayed on the right-hand side of the screen indicate
that there are more menu items above or below the currently displayed items.
SELECTION ARROW
Figure 12: 5000 Controller Display.
Once a menu has been accessed, use the arrow keys to scroll through the menu until the
desired item is selected; press
menu item, more menus will be displayed or data may be entered; follow instructions
shown on the display. Except where otherwise noted, press
return to previous menu or
out" to previous menu levels, one level at a time, until the display is returned to normal
operation screen.
(2,4,6,8) to scroll up, down, left, and right through menu items and
ARROW KEYS
(0 through 9) and the – and • keys.
NUMBER KEYS
CALIB
1
4
7
CANCEL
ENTER
CANCEL
,
CALIB
TEST
CONFIG
ANALOG
ALARM
RANGE
2 3
5 6
8 9
•
0
ENTER
0.0 ppm Vol H2O
0008-Smpl XX:XX-Cal
Alarms Analog
Passwords Timing
UP / DOWN ARROW
to select the menu item. Depending on the selected
to quit without saving. Pressing
, , and
ALARM ANALOG RANGE
to save changes and
ENTER
also "backs
CANCEL
Operation 3-3
/
TEST