Ametek 5000 Instrument Manual page 9

SPECIAL WARNINGS AND INFORMATION FOR USE OF THE
5000 CONTROLLER IN HAZARDOUS LOCATIONS
This equipment is suitable for use in Class I, Division 2, Groups ABCD or Non-Hazard-
ous Areas Only.
!
Warning - Explosion Hazard - Substitution of components may impair suitability for Class I,
Division 2.
WARNING
AVERTISSEMENT - RISQUE D'EXPLOSION - LA SUBSTITUTION DE COMPOSANTS
!
PEUT RENDRE CE MATERIAL INACCEPTABLE POUR LES EMPLACEMENTS DE
Avertissement
CLASSE I, DIVISION 2.
!
Warning - Explosion Hazard - Do not disconnect or open equipment unless power has been
switched off or the area is known to be non-hazardous
WARNING
!
AVERTISSEMENT - RISQUE D'EXPLOSION - AVANT DE DECONNECTER OU OUVRIR
L'EQUIPEMENT, COUPER LE COURANT OU S'ASSURER QUE L'EMPLACMENT EST
Avertissement
DESIGNE NON DANGEREUX.

Refer to Section 501.4(b) of the NEC or 18-152 of the CEC for proper wiring connections to the
service and installation accessible field terminals on the customer wiring module. See Section 501-
NOTE
3b(6) of the NEC or 18-172, 174 of the CEC for flexible mains connect.
!
Do not use the "Alarm" or "Relay" Functions on the customer wiring module to energize motors,
pumps, or any other device that could present an overload condition during normal operation.
CAUTION
 Refer to Customer Wiring Diagrams and Installation Instructions contained in this Manual and
the Document Package included with this Instrument.
NOTE
ix