Figure 113 Network > Wan > Dial Backup > Edit; Table 48 Network > Wan > Dial Backup > Edit - ZyXEL Communications 5 Series User Manual

Figure 113 NETWORK > WAN > Dial Backup > Edit
The following table describes the labels in this screen.
Table 48 NETWORK > WAN > Dial Backup > Edit
LABEL
AT Command
Strings
Dial
Drop
Answer
Drop DTR When
Hang Up
AT Response
Strings
CLID
Called ID
Speed
Call Control
Dial Timeout
(sec)
Retry Count
ZyWALL 5/35/70 Series User's Guide
DESCRIPTION
Type the AT Command string to make a call.
Type the AT Command string to drop a call. "~" represents a one second wait, for
example, "~~~+++~~ath" can be used if your modem has a slow response time.
Type the AT Command string to answer a call.
Select this check box to have the ZyWALL drop the DTR (Data Terminal Ready)
signal after the "AT Command String: Drop" is sent out.
Type the keyword that precedes the CLID (Calling Line Identification) in the AT
response string. This lets the ZyWALL capture the CLID in the AT response string
that comes from the WAN device. CLID is required for CLID authentication.
Type the keyword preceding the dialed number.
Type the keyword preceding the connection speed.
Type a number of seconds for the ZyWALL to try to set up an outgoing call before
timing out (stopping).
Type a number of times for the ZyWALL to retry a busy or no-answer phone
number before blacklisting the number.
Chapter 9 WAN Screens
203