Call-Triggering Packet - ZyXEL Communications 5 Series User Manual

5 Firewall log
Firewall Log Message Format
SdcmdSyslogSend(SYSLOG_FIREWALL, SYSLOG_NOTICE, buf);
buf = IP[Src=xx.xx.xx.xx : spo=xxxx Dst=xx.xx.xx.xx : dpo=xxxx | prot | rule | action]
Src: Source Address
spo: Source port (empty means no source port information)
Dst: Destination Address
dpo: Destination port (empty means no destination port information)
prot: Protocol ("TCP","UDP","ICMP", "IGMP", "GRE", "ESP")
rule: <a,b> where a means "set" number; b means "rule" number.
Action: nothing(N) block (B) forward (F)
08-01-200011:48:41Local1.Notice192.168.10.10RAS: FW 172.21.1.80
:137 |UDP|default permit:<2,0>|B
08-01-200011:48:41Local1.Notice192.168.10.10RAS: FW 192.168.77.88 :520 ->192.168.77.88
:520 |UDP|default permit:<2,0>|B
08-01-200011:48:39Local1.Notice192.168.10.10RAS: FW 172.21.1.50
|IGMP<2>|default permit:<2,0>|B
08-01-200011:48:39Local1.Notice192.168.10.10RAS: FW 172.21.1.25
|IGMP<2>|default permit:<2,0>|B

48.4.3 Call-Triggering Packet

Call-Triggering Packet displays information about the packet that triggered a dial-out call in
an easy readable format. Equivalent information is available in menu 24.1 in hex format. An
example is shown next.
ZyWALL 5/35/70 Series User's Guide
Chapter 48 System Information & Diagnosis
:137 ->172.21.1.80
->172.21.1.50
->172.21.1.25
721