Table of Contents
Advertisement
Table 218 Advanced WAN Port Setup: Call Control Parameters
FIELD
Call Control
Dial Timeout (sec)
Retry Count
Retry Interval (sec)
Drop Timeout (sec) Enter a number of seconds for the ZyWALL to wait before dropping the DTR
Call Back Delay
(sec)
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.
36.3.3 Remote Node Profile (Backup ISP)
Enter 3 in Menu 11 - Remote Node Setup to open Menu 11.3 - Remote Node Profile
(Backup ISP) (shown below) and configure the setup for your Dial Backup port connection.
Not all fields are available on all models.
Figure 372 Menu 11.3: Remote Node Profile (Backup ISP)
Rem Node Name= Dial
Active= No
Outgoing:
My Login= ChangeMe
My Password= ********
Retype to Confirm= ********
Authen= CHAP/PAP
Pri Phone #= 0
Sec Phone #=
ZyWALL 5/35/70 Series User's Guide
DESCRIPTION
Enter a number of seconds for the ZyWALL to keep trying to set up an outgoing
call before timing out (stopping). The ZyWALL times out and stops if it cannot set
up an outgoing call within the timeout value.
Enter a number of times for the ZyWALL to retry a busy or no-answer phone
number before blacklisting the number.
Enter a number of seconds for the ZyWALL to wait before trying another call after
a call has failed. This applies before a phone number is blacklisted.
signal if it does not receive a positive disconnect confirmation.
Enter a number of seconds for the ZyWALL to wait between dropping a callback
request call and dialing the co-responding callback call.
Menu 11.3 - Remote Node Profile (Backup ISP)
Press ENTER to Confirm or ESC to Cancel:
Chapter 36 WAN and Dial Backup Setup
Edit IP= No
Edit Script Options= No
Telco Option:
Allocated Budget(min)= 0
Period(hr)= 0
Schedules=
Always On= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100
623
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
