Static Route Screens; Chapter 23 Static Route Screens; Overview; What You Can Do In The Static Route Screens - ZyXEL Communications 5 Series User Manual

C
H A P T E R

23.1 Overview

This chapter shows you how to configure static routes for your ZyWALL.
The ZyWALL usually uses the default gateway to route outbound traffic from local computers
to the Internet. To have the ZyWALL send data to devices not reachable through the default
gateway, use static routes.
For example, the next figure shows a computer (A) connected to the ZyWALL's LAN
interface. The ZyWALL routes most traffic from A to the Internet through the default gateway
(R1). You create one static route to connect to services offered by your ISP behind router R2.
You create another static route to communicate with a separate network behind a router (R3)
connected to the LAN.

Figure 262 Example of Static Routing Topology

A
R3

23.1.1 What You Can Do in the Static Route Screens

• Use the IP Static Route screen
route entries.
ZyWALL 5/35/70 Series User's Guide

Static Route Screens

LAN
WAN
(Section 23.1.1 on page
23
R1
I
NTERNET
R2
451) to display the current static
451