The Ftp Screen; Figure 307 Advanced > Remote Mgmt > Telnet; Table 151 Advanced > Remote Mgmt > Telnet - ZyXEL Communications 5 Series User Manual

It is recommended that you disable Telnet and FTP when you configure SSH
for secure connections.
Figure 307 ADVANCED > REMOTE MGMT > Telnet
The following table describes the labels in this screen.
Table 151 ADVANCED > REMOTE MGMT > Telnet
LABEL
Server Port
Server Access
Secure Client IP
Address
Apply
Reset

27.8 The FTP Screen

You can use FTP (File Transfer Protocol) to upload and download the ZyWALL's firmware
and configuration files, please see
maintenance for details. To use this feature, your computer must have an FTP client.
To change your ZyWALL's FTP settings, click ADVANCED > REMOTE MGMT > FTP.
The screen appears as shown. Use this screen to specify which interfaces allow FTP access
and from which IP address the access can come.
ZyWALL 5/35/70 Series User's Guide
DESCRIPTION
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the ZyWALL using
this service.
A secure client is a "trusted" computer that is allowed to communicate with the
ZyWALL using this service.
Select All to allow any computer to access the ZyWALL using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyWALL using this service.
Click Apply to save your customized settings and exit this screen.
Click Reset to begin configuring this screen afresh.
Chapter 49 on page 725
Chapter 27 Remote Management Screens
on firmware and configuration file
509