Configuring The Traffic Redirect Screen; Figure 110 Traffic Redirect Lan Setup; Figure 111 Network > Wan > Traffic Redirect; Table 46 Network > Wan > Traffic Redirect - ZyXEL Communications 5 Series User Manual

Chapter 9 WAN Screens

Figure 110 Traffic Redirect LAN Setup

9.6 Configuring the Traffic Redirect Screen

To change your ZyWALL's traffic redirect settings, click NETWORK > WAN > Traffic
Redirect. The screen appears as shown.
For the ZyWALL 5, if the traffic redirect feature does not work after you
configure the ZyWALL's traffic redirect settings in the Traffic Redirect screen,
you may need to turn on the WAN ping check by entering sys rn pingDrop
in the command interpreter. See the CLI Reference Guide.
Figure 111 NETWORK > WAN > Traffic Redirect
The following table describes the labels in this screen.
Table 46 NETWORK > WAN > Traffic Redirect
LABEL
Active
Backup
Gateway IP
Address
Apply
Reset
198
DESCRIPTION
Select this check box to have the ZyWALL use traffic redirect if the normal WAN
connection goes down.
Type the IP address of your backup gateway in dotted decimal notation. The ZyWALL
automatically forwards traffic to this IP address if the ZyWALL's Internet connection
terminates.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
ZyWALL 5/35/70 Series User's Guide