Restore Using Ftp Session Example; Restore Via Console Port; Figure 469 Restore Using Ftp Session Example; Figure 470 System Maintenance: Restore Configuration - ZyXEL Communications 5 Series User Manual

Chapter 49 Firmware and Configuration File Maintenance

49.4.2 Restore Using FTP Session Example

Figure 469 Restore Using FTP Session Example

Refer to Section 49.3.5 on page 728
over WAN.

49.4.3 Restore Via Console Port

Restore configuration via console port by following the HyperTerminal procedure shown next.
Procedures using other serial communications programs should be similar.
1 Display menu 24.6 and enter "y" at the following screen.

Figure 470 System Maintenance: Restore Configuration

2 The following screen indicates that the Xmodem download has started.

Figure 471 System Maintenance: Starting Xmodem Download Screen

3 Run the HyperTerminal program by clicking Transfer, then Send File as shown in the
following screen.

Figure 472 Restore Configuration Example

732
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
to read about configurations that disallow TFTP and FTP
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Starting XMODEM download (CRC mode) ...CCCCCCCCC
Type the configuration file's location,
or click Browse to search for it.
Choose the Xmodem protocol.
Then click Send.
ZyWALL 5/35/70 Series User's Guide