ZyXEL Communications 5 Series User Manual page 671

Table 239 Menu 12. 1: Edit IP Static Route
FIELD
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Metric
Private
Once you have completed filling in this menu, press [ENTER] at the message "Press ENTER to
Confirm..." to save your configuration, or press [ESC] to cancel.
ZyWALL 5/35/70 Series User's Guide
DESCRIPTION
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host,
use a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
Enter the IP subnet mask for this destination.
Enter the IP address of the gateway. The gateway is an immediate neighbor of your
ZyWALL that will forward the packet to the destination. On the LAN, the gateway
must be a router on the same segment as your ZyWALL; over the WAN, the
gateway must be the IP address of one of the remote nodes.
Enter a number from 1 to 15 to set this route's priority among the ZyWALL's routes
(see Section on page 171). The smaller the number, the higher priority the route
has.
This parameter determines if the ZyWALL will include the route to this remote node
in its RIP broadcasts. If set to Yes, this route is kept private and not included in RIP
broadcast. If No, the route to this remote node will be propagated to other hosts
through RIP broadcasts.
Chapter 43 IP Static Route Setup
671