Chapter 27 Remote Management Screens
SNMP Traps
The ZyWALL will send traps to the SNMP manager when any one of the following events
occurs:
Table 153 SNMP Traps
TRAP #
0
1
4
6
6a
6b
27.9.1 Configuring the SNMP Screen
To change your ZyWALL's SNMP settings, click ADVANCED > REMOTE MGMT >
SNMP. The screen appears as shown.
Figure 310 ADVANCED > REMOTE MGMT > SNMP
512
TRAP NAME
coldStart (defined in RFC-1215)
warmStart (defined in RFC-
1215)
authenticationFailure (defined in
RFC-1215)
whyReboot (defined in ZYXEL-
MIB)
For intentional reboot :
For fatal error :
DESCRIPTION
A trap is sent after booting (power on).
A trap is sent after booting (software reboot).
A trap is sent to the manager when receiving any SNMP
get or set requirements with the wrong community
(password).
A trap is sent with the reason of restart before rebooting
when the system is going to restart (warm start).
A trap is sent with the message "System reboot by user!"
if reboot is done intentionally, (for example, download
new files, CI command "sys reboot", etc.).
A trap is sent with the message of the fatal code if the
system reboots because of fatal errors.
ZyWALL 5/35/70 Series User's Guide