Introduction - Mitsubishi Electric NZ2GN2S1-32D User Manual

INTRODUCTION

Thank you for purchasing the CC-Link IE TSN remote I/O module (hereafter referred to as I/O module).
This manual describes the procedures, system configuration, parameter settings, functions, and troubleshooting required to
use the following modules in CC-Link IE Field Network communication mode.
Before using this product, please read this manual and the relevant manuals carefully and develop familiarity with the
functions and performance of the I/O module to handle the product correctly.
When applying the program examples introduced in this manual to an actual system, ensure the applicability and confirm that
it will not cause system control problems.
CC-Link IE Field Network communication mode
When using the I/O module as an intelligent device station on CC-Link IE Field Network, select CC-Link IE Field Network
communication mode.
To operate the I/O module in CC-Link IE Field Network communication mode, set the function setting switch 1 to ON. (
Page 75 Function setting switch setting)
I/O modules with the firmware version of 02 or later are compatible with CC-Link IE Field Network
communication mode.
For other system information, refer to the following.
Page 67 SYSTEM CONFIGURATION
Relevant products
NZ2GN2S1-32D, NZ2GN2B1-32D, NZ2GNCF1-32D, NZ2GNCE3-32D, NZ2GN2S1-32T, NZ2GN2B1-32T, NZ2GNCF1-32T,
NZ2GN2S1-32TE, NZ2GN2B1-32TE, NZ2GN2S1-32DT, NZ2GN2B1-32DT, NZ2GNCE3-32DT, NZ2GN2S1-32DTE,
NZ2GN2B1-32DTE
Unless otherwise specified, this manual describes the program examples in which the remote I/O signals and
remote registers are assigned for an I/O module as follows.
• Remote input signals: RX0 to RX1F
• Remote output signals: RY0 to RY1F
• Remote register: RWr0 to RWr4F
• Remote register: RWw0 to RWw4F
For the assignment of remote I/O signals and remote registers, refer to the following.
Page 122 Program Example
6