Chapter 4 Procedures Before Operation - Mitsubishi Electric NZ2GN2S1-32D User Manual

4
PROCEDURES BEFORE OPERATION
This chapter describes the procedures before operation.
1.
Setting the IP address/station number setting switches
Set the fourth octet of IP address of I/O module.
Set the station number of the I/O module.
Page 73 Setting the IP address/station number setting switches
2.
Function setting switch setting
Set functions of the I/O module.
To operate the module in CC-Link IE Field Network communication mode, set function setting switch 1 to ON.
In the factory default switch state, the I/O module also operates with the following settings. Change the switch status as
necessary.
• Input response time setting: 1ms
• Output HOLD/CLEAR setting: CLEAR
• CC-Link IE Field Network synchronous communication mode setting function: Synchronous X/Y control mode
• Fast link-up function: Disabled
Page 75 Function setting switch setting
3.
Connection
Mount the I/O modules on the DIN rail.
Page 79 Mounting the modules on a DIN rail
4.
Wiring
Wire the power supply, Ethernet cables, and external devices to the I/O modules.
Page 80 Wiring of Terminal Block for Module Power Supply and FG
Page 86 Wiring of Ethernet Cable
Page 88 Wiring of I/O Module and External Device
5.
Parameter setting
Set the network parameters.
Page 100 Network Configuration Setting
6.
Programming
Create a program.
To replace the I/O module, follow the procedure described below:
• Power off the I/O module and remove it.
• Prepare a new I/O module and perform the procedure from step 1 to step 4. At this time, the settings of the
IP address/station number setting switches and function setting switch must be the same as the settings for
I/O module before replacement.
• Check that the RUN LED and DATA LINK LED of I/O module are on and the ERR. LED is off before
restarting control operation.
4 PROCEDURES BEFORE OPERATION
4
65