Wiring Of 40-Pin Connector - Mitsubishi Electric NZ2GN2S1-32D User Manual

Wiring of 40-pin connector

Tightening torque
Tighten the connector screws within the following tightening torque range.
Undertightening can cause short circuit, fire, or malfunction. Overtightening can damage the screw and/or module, resulting in
drop, short circuit, fire, or malfunction.
Screw type
Connector screw (M2.6 screw)
Applicable connector
The following tables list the types of 40-pin connectors and reference products of crimping tools and pressure-displacement
tools.
■40-pin connector
Type
Soldering type connector (straight type)
Crimping type connector (straight type)
IDC type connector (straight type)
Soldering type connector (dual purpose (straight/oblique) type)
*1 When using 40 pins, use cables whose sheath outside diameters are 1.3mm or shorter. Select cables according to the amount of current
to flow.
■40-pin connector crimping tool and pressure-displacement tool
Type
Crimping tool
Pressure-displacement
tool
For how to wire the connectors and how to use the crimping tool and pressure-displacement tools, contact FUJITSU
COMPONENT LIMITED.
Signal name and wiring
For the signal names of the terminal block and wiring of the external device, refer to the specifications of each module. (
Page 18 Performance Specifications)
Incorrect wiring can cause malfunction of or damage on the module.
6 INSTALLATION AND WIRING
94
6.8 Wiring of I/O Module and External Device
Model
FCN-363T-T005/H
FCN-367T-T012/H (locator plate)
FCN-707T-T001/H (cable cutter)
FCN-707T-T101/H (hand press)
Tightening torque range
0.20 to 0.29Nm
Model Applicable wire size
*1
A6CON1 0.08 to 0.3 (28 to 22 AWG), (stranded wire)
A6CON2 0.08 to 0.24 (28 to 24 AWG), (stranded wire)
A6CON3 0.08 (28 AWG) (stranded wire)
0.25mm (30 AWG) (solid wire)
Flat cable (intervals of 1.27mm)
*1
A6CON4 0.08 to 0.3 (28 to 22 AWG), (stranded wire)
Contact
FUJITSU COMPONENT LIMITED