Dräger Babyleo TN500 Instructions For Use Manual page 61

5.3.2 Connecting the oxygen cylinder
Procedure:
1 Place a full oxygen cylinder in the gas cylinder holder and fasten with the hook-
and-loop straps.
2 Check that the pressure reducer protrudes over the upper edge of the gas
cylinder holder and is secured by the protection bar (4).
3 Feed the compressed gas hose on the rear of the gas cylinder holder
downwards
and secure with the clamp (3).
Fig. 31
4 Note the contents of the product label on the oxygen connection. Screw the
compressed gas hose to the oxygen connection (1) located closest to the
device.
5 Place the compressed gas hose in the strain relief of the device (2). Screw the
strain relief tight.
✓ The oxygen cylinder is attached.
The gas cylinder holder can also be used for compressed air cylinders.
Compressed air cylinders can be attached to both sides of the device. Further
information about gas cylinders can be found in the technical data.
Instructions for use Babyleo TN500 SW 1.0n
4
3
Connecting the oxygen cylinder
Assembly and preparation
2
61