Dräger Babyleo TN500 Instructions For Use Manual page 170

Reprocessing
170
4 Before the mini-wall can be removed,
release the fastenings: from the inside, take
hold of the mini-wall exactly in the center
(1). Push the lower half of the mini-wall out-
wards (away from the mattress tray) and as
soon as the mini-wall is free at the center,
tilt it inwards with a rotational movement (2)
(towards the mattress tray). Remove the
mini-wall.
5 If the heated mattress and the scale are
available, remove both cables on the rear of
the sensor wall. Remove the heated mat-
tress or the SoftBed from the mattress tray.
6 Remove the mattress tray.
7 Open the X-ray flaps on both sides. Pull out
the x-ray tray as far as it will go, lift it slightly
and then pull it out completely.
8 Remove the bed support.
9 Remove the T-bars.
Instructions for use Babyleo TN500 SW 1.0n