Dräger Babyleo TN500 Instructions For Use Manual page 50

Operating concept
CAUTION
Uneven heat distribution
If the mattress tray is tilted, heat may be unevenly distributed on the mattress tray.
► If the mattress tray is tilted, make sure that the patient is adequately warmed.
Procedure:
1 Adjust the mattress tray height with the upper buttons:
– The right-hand key (1) raises the mattress tray.
– The left-hand key (2) lowers the mattress tray.
Fig. 22
– In incubator operation set the lowest position for the mattress tray so that
– In radiant warmer operation Dräger recommends setting the highest position
2 Adjust the bed-tilt mechanism with the lower buttons:
– The two keys (3 and 4) tilt the mattress tray in the direction of the arrow.
Fig. 23
 When the maximum mattress tray tilt is reached, the LED in the button (3 or
✓ The height and tilt angle of the mattress tray are set.
50
Mattress tray control panel
there is as much space as possible for the patient. This position also offers
good access to the patient.
 When the lowest position is reached, the LED in the button (2) goes out.
for the mattress tray. This position provides the most effective warming for
the patient. This position also offers good access to the patient.
 When the highest position is reached, the LED in the button (1) goes out.
3
4
Mattress tray control panel
When the mattress tray reaches the horizontal position, the mattress tray
stops automatically. The mattress tray can be tilted further by pressing the
corresponding button again.
4) goes out.
1
2
Instructions for use Babyleo TN500 SW 1.0n