Radiant Warmer Operation - Dräger Babyleo TN500 Instructions For Use Manual

6.6

Radiant warmer operation

This chapter describes how to set which modes and settings in radiant warmer
operation.
6.6.1 Overview of radiant warmer operation
When the hood is open, the device is automatically operated as a radiant warmer.
The device displays the user interface for radiant warmer operation. The radiant
warmer power is indicated on the user interface by means of bars. In skin
temperature mode, the radiant warmer power is regulated by means of the set
value for the skin temperature. In manual mode the radiant warmer power can be
set manually. In both modes the radiant warmer power is reduced according to the
ambient temperature. The bars on the user interface show the maximum possible
radiant warmer power in each situation. If the mattress tray is tilted, the radiant
warmer power is adjusted to compensate for an uneven radiation distribution on the
mattress tray. If the side of the mattress tray against the sensor wall is raised, the
uneven radiation distribution on the mattress tray can only be compensated for up
to a radiant warmer power of 80 %. If a radiant warmer power of over 80 % is set,
the lower end of the mattress tray is warmed to a slightly lesser degree.
Fig. 36
No.
1
2
Instructions for use Babyleo TN500 SW 1.0n
2
Standard view in radiant warmer operation with manual mode activated
Designation
Radiant warmer
Therapy bar
Description
Shows the radiant warmer power numerically
and as bars.
Shows the available modes in radiant warmer
operation. In this example, manual mode is
activated.
Operation
1
71