Sony MVS-8000 User Manual page 397

Modifying the wipe pattern edge
1
2
3
4
5
396
Basic Procedure for Wipe Settings
In the M/E-1 >Wipe menu, select HF4 'Edge/Direction.'
The Edge/Direction menu appears.
In the <Edge> group, select the edge type.
Border: border
Soft: soft edge
Soft Border: soft border
For an overview of the edge types, see "Edge" (page 61).
Set the parameters according to the selection in step 2.
• When border is selected
Knob Parameter Adjustment
1 Width Border width
• When soft edge is selected
Knob Parameter Adjustment
1 Soft Edge softness
• When soft border is selected
Knob Parameter Adjustment
1 Width Border width
2 Inner Soft Border inner softness
3 Outer Soft Border outer softness
When you selected border or soft border, select the edge fill signal in the
<Edge Fill> group.
Utility 2 Bus: signal selected on the utility 2 bus
Matte: signal from the dedicated color matte generator
Depending on the operation in step 4, carry out the following operation.
When 'Utility 2 Bus' is selected: Press the key delegation button
[UTIL2], turning it on, and select the signal in the key row.
When 'Matte' is selected: In the same Edge/Direction menu, press [Matte
Adjust] to display the Matte Adjust menu, then adjust the single-color
or two-color combination color matte. Select whether to use a single-
Setting values
0.00 to 100.00
Setting values
0.00 to 100.00
Setting values
0.00 to 100.00
0.00 to 100.00
0.00 to 100.00