Sony MVS-8000 User Manual page 233

Changing the key assignment for each output (Misc menu)
In Multi Program 2 mode you can change the key assignments independently.
The following describes an example using M/E-1, but the operation is the same
for other banks.
Notes
• This setting is linked to the setting in the Engineering Setup >Switcher >
• It is not possible to make this setting while the above PGM Config menu is
1
2
Keys recalled in a snapshot recall
If a snapshot is recalled independently on main or sub, this only retrieves the
settings for the key assigned to the recalled side. For example, if key 1 and key
2 are assigned on main, and key 3 and key 4 are assigned on sub, then if you
recall a snapshot on main, this only retrieves the settings for key 1 and key 2,
and the state of key 3 and key 4 assigned on sub is not affected.
Changing the matrix size to Standard
When using a router, if the matrix size is set to [Compact (128×128)], it is not
possible to control the utility 3 bus on the S-Bus. When using Multi Program
2, in the <Matrix Size> group of the Engineering Setup >Router/Tally >Router
menu, select [Standard (136×138)].
For details, see "Assigning switcher inputs and outputs to S-Bus space" in
Chapter 16 (Volume 2).
As for the bus number of the utility 3 bus, a DME Key bus number is used as
follows.
No.
70
85
100
115
232
Multi Program 2
Config >PGM Config menu.
locked, or [Recall M/E Config] (see previous item) is set to Off.
In the M/E-1 menu, select first VF7 'Misc,' then HF5 'Key Assign.'
The Key Assign menu appears, and the current key assignment is shown
in the status area.
Change the setting in "Key Enable" as required.
Bus (Standard)
M/E-1 DME Key
M/E-2 DME Key
M/E-3 DME Key
P/P DME Key
Bus (MP2)
M/E-1 Utility3
M/E-2 Utility3
M/E-3 Utility3
P/P Utility3