Signal Name Display - Sony MVS-8000 User Manual

Selection of signals linked with the audio mixer
When you select a signal in a switcher bank background A row or AUX bus
control block which is set to be linked with the audio mixer, the program output
of the audio mixer follows the signal selection.
For details of the setting, see Chapter 16, "Cross-Point Settings (Xpt Assign
menu)" (Volume 2).
Note
• For details of audio mixers that can be connected, contact your Sony service
or sales representative.
• When the signal is switched with a snapshot, keyframe, and so on, the audio
mixer is not linked.
• When bus fixed mode is selected in setup (see page 41), the audio mixer
program output is linked to the bus output as the background.

Signal Name Display

You can attach a name (source name) to each signal assigned to a cross-point
button, with a maximum of 16 characters.
• The source name displays in the cross-point control block and auxiliary bus
control block show the source names of the video signals assigned to
numbers 1 to 12 (or 11).
• To display the source names for shifted numbers (13 to 24 or 12 to 22), press
the [SHIFT] button to the right of the key row delegation buttons.
• To display the source names of the key signals assigned to button numbers,
hold down one of the key delegation buttons [KEY1] to [KEY4] or [DSK1]
to [DSK4] buttons or, for the auxiliary bus control block, hold down the
[KEY] button.
Colors of lit cross-point buttons
In a particular row of cross-point buttons, only the last pressed button is
effective, and lights amber or red. The amber indicates the "low tally" state,
and the red indicates the "high tally" state, to indicate whether or not the
selected signal appears in the final output video.
Color
Amber
Red
Significance of colors of lit cross-point buttons
State
Low tally
High tally
Significance
Does not appear in final output video
Appears in final output video
Signal Selection
29