Safe Title Settings - Sony MVS-8000 User Manual

3

Safe Title Settings

Switching the safe title function on or off
1
2
3
500
Misc Menu Operations
At this point, if auto side flags are on, this automatically adds side flags to
the 4:3 video material. (See "Settings for Switcher Configuration (Config
Menu)" in Chapter 16 (Volume 2).)
Use either of the following methods to turn the side flags on.
• Use the Misc >Enable >Side Flags menu. (See page 498)
• Use a cross-point button operation. (See previous item.)
This adds side flags to the 4:3 video material.
In the menu control block, press the top menu selection button [MISC] and
select VF2 'Safe Title.'
The Misc >Safe Title menu appears.
Using any of the following methods, select the signal to which the settings
apply.
• Directly press the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob to make the setting.
Knob Parameter Adjustment
1 Output Signal to which the settings
apply
Notes
• It is not possible to change the setting for the output for which the safe
title is set off in a Setup menu.
• The safe title function cannot be used for output signals for which
through mode is set to Enable in a Setup menu.
For more information about the Setup menu settings referred to above, see
"Signal Input Settings (Input Menu)" and "Signal Output Settings (Output
Menu)" in Chpater 16 (Volume 2).
Press [Safe Title] to set it on or off.
Setting values
1 to 48