For a normal edge, when [Soft Edge] is enabled, [Key Drop] is kept on.
8
To make separate fine adjustments to the positions of the left, right, top,
and bottom of the source edge, press [Fine Key], to set it on, and adjust the
following parameters.
Knob
Parameter
1
Top
2
Left
3
Right
4
Bottom
Knob
Parameter
1
H Phase
2
V Phase
Note
In the emboss function it is not possible to set [Fine Key] on.
• When the edge type is normal, drop border or shadow, enabling the [Fine
Key] function keeps [Key Drop] on.
• When applying a border to the key edge, enabling the [Fine Key]
function halves the border width setting range.
To fix key fill and key source in key drop off mode
1
In the Edge menu, press [Key Delay Mode].
The Key Delay Mode menu appears.
Note
This function is only supported on the MVS-8000G.
2
Press [Frame Delay], setting it to On.
Note
This function uses the resizer, and therefore the expected result of the
setting may not be obtained if conditions do not allow the resizer to be
used.
Parameter group [1/2]
Adjustment
Key top edge position
Key left edge position
Key right edge position
Key bottom edge position
Parameter group [2/2]
Adjustment
Key horizontal position
Key vertical position
Key Setting Operations Using Menus
Setting values
–2.00 to +2.00
–2.00 to +2.00
–2.00 to +2.00
–2.00 to +2.00
Setting values
Left edge position
value shown
Top edge position
value shown
347