Setup; Overview Of Setup; System Setup - Sony MVS-8000 User Manual

Setup

Overview of Setup

Various settings are required, in order to operate the switcher, control panel,
DME, external devices, and so on, connected together in a single system.
This is referred to as "setup," and you can carry out the setup operations from
the Engineering Setup menu.
For details of the operations, see Chapter 16 "Engineering Setup" (Volume 2).
The settings in the Engineering Setup menu are grouped under the following
headings.
• System setup (System): Settings relating to the whole system (see the
• Panel setup (Panel): Settings particular to the control panel (see page 189)
• Switcher setup (Switcher): Settings particular to the switcher processor
• DME setup (DME): Settings particular to the DME processor (see page
• DCU setup (DCU): DCU input and output settings (see page 196)
• Router/tally setup (Router/Tally): Router interface and tally settings (see

System Setup

The system setup settings apply to the whole system. Here the "whole system"
refers to all devices connected on the Control LAN.
The DCU is connected through the control panel, but is also included in the
"whole system."
You can make the following settings.
Network configuration (Network Config)
This provides automatic configuration of all devices connected to the Data
LAN (excluding the DCU), and displays a list of them.
System configuration (System Config)
Specify the overall system operation mode and the hierarchical relationship of
the devices.
182
Setup
following section "System Setup.")
(see page 192)
195)
page 196)