Sony MVS-8000 User Manual page 422

The Modify menu appears.
2
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
For a pattern in one-channel mode: press [1st Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channel. You can select more than one channel at
the same time.
3
Press [Size], turning it on.
4
Set the following parameters.
Knob
1
a) The effect size when [Size] is off is taken as 100.00%.
Display indications when multiple channels are selected at the same
time
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
Adjusting the DME wipe pattern cropping
Note
When pattern numbers 1701 and 1702 are selected, crop cannot be used.
1
In the M/E-1 >DME Wipe menu, select HF5 'Modify.'
The Modify menu appears.
2
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
For a pattern in one-channel mode: press [1st Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channel. You can select more than one channel at
the same time. Some patterns need no selection which is fixed in the
<Ch Select> group.
3
In the <Crop Mode> group, press [Crop], turning it on.
4
Set the following parameters.
Parameter Adjustment
Size Set size of effect
Setting values
0.00 to 200.00
Basic Procedure for DME Wipe Settings
a)
421