Sony MVS-8000 User Manual page 230

3
Select the switcher bank, then in the <PTN LIMIT/LIMIT SET/KF Button
Assign> group, press [Main/Sub].
You can now use the [PTN LIMIT] button as [MAIN], and the [LIMIT
SET] button as [SUB].
To assign to the wipe direction selection buttons (NORM and
NORM REV) in the transition control block
For details of the transition control block, see page 247.
1
In the Transition Module menu, select the switcher bank.
2
In the <NORM/NORM REV/REV Button Assign> group, press [Main/
Sub].
You can now use the [NORM] button as [MAIN], and the [NORM/REV]
button as [SUB].
To assign to macro buttons in the cross-point control block
For details of the cross-point control block, see page 245.
1
In the Engineering Setup >Panel >Config menu, press [Program Button].
The Program Button menu appears.
2
Press [Xpt Module].
The Xpt Module menu appears.
3
Select the switcher bank, then in the <PRE MCRO/POST MCRO> group,
press [Main Sub].
You can now use the [PRE MCRO] button as [MAIN], and the [POST
MCRO] button as [SUB].
To assign macro operations to different buttons
If in the above operation you assigned a Multi Program 2 function to the macro
buttons, you can assign the PRE MCRO and POST MCRO functions to
different buttons.
For details, see "Assigning functions to user preference buttons" or
"Assigning a function to a memory recall button in the utility/shotbox control
block" in Chapter 16 (Volume 2).
229
Multi Program 2