Table of Contents
Advertisement
Tension Electronics PFEA113, User Manual
Chapter 3 Commissioning
3.4 Using the Panel Buttons
3.4.1 Navigating and Confirming
3.4.2 Changing Numerical Values and Parameters
3-2
Display
Power
Set language
[English]
SetTensionAt10V
XXXXXX N
•
X indicates a numerical value.
•
Z indicates that a parameter can be chosen from a list.
SetTensionAt10V
[XXXXXX] N
To change a numerical value, X, or parameter, Z, press
then placed within brackets [XXXXXX] or [ZZ] to show that it can be changed.
If it is a "Z" parameter, use
is shown on the display press
the brackets around the value disappear.
If you have pressed
so that the parameter is enclosed by brackets, you can cancel the
entering mode by pressing
is pressed the old value is displayed without brackets.
To change a numerical value, press
digit can be changed with
the second digit can be changed with
been set, the new value is saved and displayed without brackets.
Using
when entering a numerical value means returning to the previous digit. By pressing
a sufficient number of times you will leave the entering mode and the old value will be
displayed without brackets.
Button
How to use it
Returns to previous menu. Sometimes
this button must be pressed repeatedly
to get back to the desired menu.
Status
Steps up in a list.
Steps down in a list.
Steps to next main menu.
OK (acknowledgment) button. Confirms
a selection or a parameter setting.
NominalLoad
ZZ kN ZZ lbs
Nominal load
[ZZ kN ZZ lbs]
and
to move up or down in the list. When the desired value
. When
is pressed the new parameter value is saved and
. The selections made with
so that brackets appear around the value. Then the first
and
. When the first digit has the desired value press
and
. When pressing
. The numerical value or parameter is
and
will not be stored. If
after the last digit has
3BSE029382R0101 Rev C
, then
Hide quick links:
Advertisement
Table of Contents
