Cessna TURBO CENTURION T210M 1978 Pilot Operating Handbook page 372

CESSNA 400B IFCS
(TYPE IF-550A)
PILOT'S OPERATING HANDBOOK
SUPPLEMENT
10. MODE SELECTOR HDG Button -- PUSH.
~
11. MODE SELECTOR HDG Annunciator -- CHECK ON (green light
illuminated). ·
12. PITCH Command Wheel -- ROTATE for desired climb attitude.
FLIGHT DIRECTOR MODE
BEFORE TAKEOFF AND LANDING:
1. AP ON-OFF Rocker Switch -- PUSH OFF.
2. MODE SELECTOR Rheostats -- ADJUST illumination intensities.
3. MODE SELECTOR AP Annunciator -- CHECK OFF (green light
extinguished).
4. MODE SELECTOR FD Annunciator -- CHECK OFF (green light
extinguished).
CLIMB:
1. Airplane Climb Attitude -- ESTABLISH.
2. MODE SELECTOR FD Button -- PUSH ON and observe that
command bars appear on FD Indicator. .---.
3.
MODE SELECTOR FD Annunciator -- CHECK ON (green light
illuminated).
NOTE
If pitch command bar is not aligned in pitch with the
symbolic aircraft, readjust flight director indicator's sym-
bolic airplane alignment knob.
4. Autopilot Lateral TRIM Knob -- ADJUST as required to center
vertical command bar.
5. Airplane Control Wheel/Elevator Trim Switch -- OPERATE to
keep dot on symbolic airplane aligned with command bars, satis- ,,.._
fying command signal.
NOTE
If
climb attitude is changed, press PITCH SYNC button on
control wheel to realign pitch command bar with symbolic
airplane.
LEVEL FLIGHT:
14
1.
MODE SELECTOR ALT Button -- PUSH.
2. MODE SELECTOR ALT Annunciator -- CHECK ON (green light
illuminated).