Table of Contents
Advertisement
SECTION 8
HANDLING, SERVICE
&
MAINTENANCE
CESSNA
MODELT210M
with moderate pressure until all dirt, oil scum and bug stains are removed.
Allow the cleaner to dry, then wipe it off with soft flannel
cloths.
If
a windshield cleaner is not available, the plastic can be cleaned with
soft cloths moistened with Stoddard solvent to remove oil and grease.
NOTE
Never use gasoline,
benzine, alcohol,
acetone,
carbon
tetrachloride, fire extinguisher or anti-ice fluid, lacquer
thinner or glass cleaner to clean the plastic. These mate-
rials will attack the p
l
astic and may cause it to
craze.
Follow by carefully washing with a mild detergent and plenty of water.
Rinse thoroughly, then dry
with
a clean moist
chamois.
Do not rub the
plastic with a dry cloth since this builds up an electrostatic charge which
attracts dust. Waxing with a good commercial wax will finish the cleaning
job. A thin, even coat of wax, polished out by hand with clean soft flannel
cloths,
will fill in minor scratches and help prevent further scratching.
Do not use a canvas cover on the windshield unless freezing rain or
sleet is anticipated since the cover may scratch the plastic surface.
PAINTED
SURFA.
C ES
The painted exterior surfaces of your new Cessna have a durable, long
lasting finish and, under normal conditions, require no polishing or
buffing. Approximately 15 days are required for the
paint
to cure com-
pletely; in most cases, the curing period will have been completed prior to
delivery of the airplane. In the event that polishing or buffing is required
within the curing
period,
it is recommended that the work be done by
someone experienced in handling uncured paint. Any Cessna Dealer can
accomplish this work.
Generally, the painted surfaces can be kept bright by washing with
water and mild soap, followed by a rinse with water and drying with cloths
or a chamois. Harsh or abrasive soaps or detergents which cause corrosion
or scratches should never be used. Remove stubborn oil and grease with a
cloth moistened with Stoddard solvent.
Waxing is unnecessary to keep the painted surfaces bright.
However,
if
desired, the airplane may be waxed with a good automotive wax. A heavier
coating of wax on the leading edges of the wings and tail and on the engine
nose cap and propeller spinner will help reduce the abrasion encountered
in these areas.
When the airplane is parked outside in cold climates and it is necessary
8-12
Hide quick links:
Advertisement
Table of Contents
