Cessna TURBO CENTURION T210M 1978 Pilot Operating Handbook page 298

CESSNA 400 TRANSPONDER
AND ENCODING ALTIMETER
PILOT'S OPERATING HANDBOOK
SUPPLEMENT
SECTION 2
LIMITATIONS
There is no change to the airplane limitations when this avionic
equipment is installed.
SECTION 3
EMERGENCY PROCEDURES
TO TRANSMIT AN EMERGENCY SIGNAL:
(1)
Function Switch -- ON.
(2) Reply-Code Selector Switches -- SELECT 7700 operating code.
(3)
ID Switch -- DEPRESS then RELEASE to effect immediate identi-
fication of aircraft on ground controller's display.
TO TRANSMIT A SIGNAL REPRESENTING LOSS OF ALL
COMMUNICATIONS (WHEN IN A CO~TROLLED ENVIRONMENT):
(1) Function Switch -- ON.
(2) Reply-Code Selector Switches -- SELECT 7700 operating code
for 1 minute; then SELECT 7600 operating code for 15 minutes and
then REPEAT this procedure at same intervals for remainder of
flight.
(3) ID Switch -- DEPRESS then RELEASE at intervals to effect
immediate identification of aircraft on ground controller's display.
SECTION 4
NORMAL PROCEDURES
BEFORE TAKEOFF:
(1) Function Switch -- SBY.
TO TRANSMIT MODE A (AIRCRAFT IDENTIFICATION) CODES IN
FLIGHT:
(1) Reply-Code Selector Switches -- SELECT assigned code.
4