Cessna TURBO CENTURION T210M 1978 Pilot Operating Handbook page 151

~
CESSNA
MODELT210M
SECTION 7
AIRPLANE & SYSTEMS DESCRIPTIONS
The four-way adjustable front and center passenger's seats may be
moved forward and aft, and the seat back angle is infinitely adjustable.
Position the seat by lifting up on the tubular handle under the center of the
seat bottom of the front passenger's seat, or the handle under the inboard
corner of the center passenger's seats, and slide the seat into position; then
release the handle and check that the seat is locked in place. The seat back
angle of either front or center passenger seats may be adjusted by rotating
a crank under the outboard corner of the seat. The seat bottom angle will
change as the seat back angle changes, providing proper support. The seat
backs will also fold full forward.
The aft passenger's seats consist of a fixed position one-piece seat
bottom and a one-piece fold-down seat back.
If
the seats are not to be
occupied, a camming action permits the seat back to fold down completely
flat, providing more space for baggage. To fold down the seat back, grasp
the top edge and rotate it downward.
Headrests are available for any of the seat configurations. To adjust
the headrest, apply enough pressure to it to raise or lower it to the desired
level. The headrest may be removed at any time by raising it until it
disengages from the top of the seat back.
SEAT BELTS AND SHOULDER HARNESSES
All seat positions are equipped with seat belts (see figure 7-4). The
pilot's and front passenger's seats are also equipped with separate
shoulder harnesses; separate shoulder harnesses are available for the
remaining seat positions. Integrated seat belt/ shoulder harnesses with
inertia reels can be furnished for the pilot's and front passenger's seat
positions
if
desired.
SEAT BELTS
The seat belts used with the pilot, front passenger, and center pas-
senger seats are attached to fittings on the floorboard. The buckle half is
inboard of each seat and the link half is outboard of each seat. The belts for
the aft seat are attached to the seat frame, with the link halves on the left
and right sides of the seat bottom, and the buckles at the center of the seat
bottom.
To use the seat belts for the front and center seats, position the seat as
desired, and then lengthen the link half of the belt as needed by grasping
the sides of the link and pulling against the belt. Insert and lock the belt
link into the buckle. Tighten the belt to a snug fit. Seat belts for the aft seat
a re used in the same manner as the belts for the front and center seats. To
7-15