Table of Contents
Advertisement
Split the documents into
sections for individual
programming.
Select [Build Job] and then
[On].
Programme the job
requirements for the first
section of the job.
Load only the first section in
to the document feeder or
place the document on the
glass.
Select [Start].
When the first section has
finished scanning remove the
originals.
From the [Build Job] screen
make selections for the next
section of the job and select
[Start].
Repeat the steps above for
each selection of the job.
After the last section has
been scanned, select [End
Build Job] to indicate that
the job has been completed.
The machine will complete
the quantity selected.
Xerox Document Centre 440/432/430/426/425/420 User Guide
NOTE: If more than a quantity of 1 has been selected, the
machine, depending on the features programmed, will copy 1
set of each section. The remaining sets will be copied at the
end of the job.
Page 3-49
Advertisement
Table of Contents
