Christie E Series Service Manual page 81

b. The switch (SW1) should be pushed to the "Flash" side.
NOTE: If the switches are not set properly the following symptoms will occur.
a. If switch "SW1" or "SW7" is not set properly, regardless if other switches are set properly or not,
there will be no light on and the fan will be noisy.
b. If switch "SW2" is not set properly and switch "SW1" OR "SW7" are set properly, there will be no
light on. Then "LAMP 1" and "LAMP 2" LED will light yellow (short blink); "SHUTTER" and
"STATUS" LED will light yellow. Then "LAMP 1" and "LAMP 2" will light red (short blink);
"STATUS" LED will light red.
c. If only switch "SW9" is not set properly and the other switches are set properly the symptom will be
normal.
15. Perform procedure in
E Series 675/775 Service Manual
020-000546-04 Rev. 1 (04-2017)
F 5-61 M
IGURE AIN
3.6.3 Color Wheel Index
Section 5: Parts and Module Replacement
B S
OARD WITCHES
Adjustment.
5-35