Lamp Exhaust Fan; Procedure - Christie E Series Service Manual

Section 5: Parts and Module Replacement
6. Pull edge of frame to release fan. See Figure 5-17.
7. Remove fan.
8. Remove rubber gasket from fan and install on new fan. See Figure 5-18.
9. Install new fan(s) in frame.
10. Install frame into the projector chassis.
11. Install screws (2).
12. Route harness cables through proper retaining clips.
13. Connect harnesses.

5.2.15Lamp Exhaust Fan

Replacement Time: 45 minutes

Procedure:

1. Remove Top Cover. See
2. Remove Top Shield. See
3. Remove Lamp Assemblies. See
4. Remove Rear Exhaust Fans. See steps 4 & 5 of
5. Disconnect harness (Fan 8) from Connector-A Board.
6. Disconnect harness (Fan 9) from Connector-B Board.
7. Remove screws (4) securing metal cover. See Figure 5-19.
5-12
F 5-17 R
IGURE ELEASE
F 5-18 R
IGURE EMOVE
5.2.5 Top Cover.
5.2.7 Top Shield.
5.2.4 Lamp Assembly.
5.2.14 Rear Exhaust
F
AN
R G
UBBER ASKET
Fans.
E Series 675/775 Service Manual
020-000546-04 Rev. 1 (04-2017)