Shutter - Christie E Series Service Manual

Section 5: Parts and Module Replacement
1. Remove Top Cover. See
2. Remove Top Shield. See
3. Remove DA Board (2 screws). See Figure 5-47.
4. Remove Shutter Cover (4 screws). See Figure 5-48.
5. Cut plastic clip to remove cable harnesses.
6. Disconnect Shutter harness from Connector-A Board.
7. Disconnect Sensor harness from Connector-B Board.
8. Lift Shutter assembly out of projector. See Figure 5-49.
9. Replace Shutter.
5-28
5.2.5 Top Cover.
5.2.7 Top Shield.
F 5-47 DA B
IGURE
F 5-48 S
IGURE HUTTER
F 5-49 R S
IGURE EMOVE
S
OARD CREWS
C S
OVER CREWS
A
HUTTER SSEMBLY
E Series 675/775 Service Manual
020-000546-04 Rev. 1 (04-2017)