Christie E Series Service Manual page 90

Section 6: Firmware
d. Click Next in the update wizard.
4. Connect the PC to the projector.
a. Connect the RJ-45 cable to the projector and the
computer.
b. Set the Default Gateway and Subnet Mask of the
computer to match the projector.
c. Set the IP address of the computer to match the
first three numbers of the projector (for example,
with projector 192.168.000.100, set the computer
to 192.168.000.xxx where 'xxx' is not 100).
d. Enter the projector IP address.
e. Click Next.
5. Click Next. NOTE: The firmware will begin the upgrading.
6. When complete, verify that the projector is running the updated firmware version. Example, version
A29.02.
6-8 E Series 675/775 Service Manual
020-000546-04 Rev. 1 (04-2017)