Repair Cautions; General Precaution; Ac /Power Precautions; Lamp Precautions - Christie E Series Service Manual

5.1.1 Repair Cautions

5.1.2 General Precaution

5.1.3 AC /Power Precautions

5.1.4 Lamp Precautions

E Series 675/775 Service Manual
020-000546-04 Rev. 1 (04-2017)
Ensure the projector is disconnected from AC power before you start testing,
removing, or installing modules.
Do not operate the projector with any internal parts removed. If for testing
purposes, you must operate the projector without the lid and/or lamp door,
ensure to wear UV glasses and stand well back from the projector at all times.
Do NOT look into lens.
FIRE HAZARD! Keep hands, clothes and all combustible material away from
the concentrated light beam of the projector. Position all cables where they
cannot contact hot surfaces or be pulled or tripped over.
All installation and maintenance procedures must be performed by a Christie
accredited service technician.
Projector must be operated in an environment that meets operating
specifications.
Use only the AC power cord supplied. Do not attempt operation if the AC
supply and cord are not within the specified voltage and power range. Refer
to the license label on the bottom of the projector or for rated voltage and
power.
The projector is equipped with a 3-wire plug with a grounding pin. This is a
safety feature. If you are unable to insert the plug into the outlet, contact an
electrician to have the outlet replaced. NEVER defeat the safety purpose of
the grounding-type plug.
Do not allow anything to rest on the power cord. Locate the power cord
where persons walking on it or objects rolling over it cannot damage the cord.
Never attempt to access the lamp while the lamp is ON. After turning the
lamp OFF, it is crucial that you wait at least 10 minutes before handling the
lamp. This provides sufficient time for the lamp cooling fans to properly cool
the lamp.
Section 5: Parts and Module Replacement
5-3