Procedure - Christie E Series Service Manual

Section 5: Parts and Module Replacement
7. Disconnect harnesses (2). See Figure 5-35.
8. Remove Power Supply Cover.
9. Squeeze plastic stand offs (4) to remove Lamp Driver Board. See Figure 5-36.
10. Replace Lamp 2 Driver Board.
5.2.22Power Supply
Replacement Time: 30 minutes

Procedure:

1. Remove Top Cover. See
2. Remove Top Shield. See
3. Disconnect all harnesses from Connector-A Board. See
4. Remove Power Supply Cover screws (5). See Figure 5-34.
5. Lift Power Supply Cover and disconnect all harnesses attached to components on Power Supply shield.
6. Remove Power Supply Cover.
7. Disconnect all harnesses attached to Power Supply.
5-22
F 5-35 L 2 D
IGURE AMP RIVER
F 5-36 L
IGURE AMP
5.2.5 Top Cover.
5.2.7 Top Shield.
B H
OARD ARNESSES
2 D B
RIVER OARD
5.2.18 Connector-A Board.
E Series 675/775 Service Manual
020-000546-04 Rev. 1 (04-2017)