Christie E Series Service Manual page 54

Section 5: Parts and Module Replacement
6. Remove Fan.
7. Remove gasket from exhaust port of fan noting placement of gasket around exhaust opening.
8. Place gasket (removed above) on new fan assembly on same sides of exhaust opening.
9. Install new fan. NOTICE: Make sure harness cable is routed as per Figure
10. Connect harness (Fan 7 to Connector-B Board).
5-8
F 5-8 C
IGURE OOLING
F 5-9 C F
IGURE OOLING AN
F 5-10 C F
IGURE OOLING
F - L 1
AN AMP
- L 1 G
AMP ASKET
- L 1 H
AN AMP ARNESS
5-10.
E Series 675/775 Service Manual
020-000546-04 Rev. 1 (04-2017)