Environment And Installation; Environmental Conditions - Epson ProSix S5 Series Manual

Setup & Operation 3. Environment and Installation

3. Environment and Installation

Installation and transportation of robots and robotic equipment shall be performed
by qualified personnel and should conform to all national and local codes.

3.1 Environmental Conditions

A suitable environment is necessary for the robot system to function properly and safely.
Be sure to install the robot system in an environment that meets the following conditions:
Ambient temperature*1
Ambient relative humidity 20% to 80% (no condensation)
First transient burst noise
Electrostatic noise
Environment
*1 The ambient temperature conditions are for the Manipulators only. For the Controller
the Manipulators are connected to, refer to the Controller manual.
NOTE
Manipulators are not suitable for operation in harsh environments such as painting areas,

etc. When using Manipulators in inadequate environments that do not meet the above
conditions, please contact us.
28
Item
0 deg C to 45 deg C (with minimum temperature variation)
2 kV or less (Power wire)
1 kV or less (Signal wire)
4 kV or less
· Install indoors.
· Keep away from direct sunlight.
· Keep away from dust, oily smoke, salinity, metal
powder or other contaminants.
· Keep away from flammable or corrosive solvents
and gases.
· Keep away from water.
· Keep away from shock or vibration.
· Keep away from sources of electric noise.
Conditions
S5 Rev.5