Mitsubishi Electric 800 Series Instruction Manual page 400

16.2
List of parameters changed from the initial values
Parameters changed from their initial values can be displayed.
Operating procedure
1.
Turning ON the power of the inverter
The operation panel is in the monitor mode.
2.
Selecting the parameter setting mode
Press the MODE key to choose the parameter setting mode. (The parameter number read previously appears.)
3.
Selecting the parameter
Turn the setting dial or press the UP/DOWN key until "Pr.CH" (Initial value change list) appears, and set the SET key.
"P.---" blinks and then remains displayed.
4.
Checking the Initial value change list
Turn the setting dial or press the UP/DOWN key after blinking stops to display the parameter numbers that have
been changed from their initial values in order.
● When the SET key is pressed with a changed parameter displayed, the parameter settings can be changed as
they are. (Parameter numbers are no longer displayed in the list when they are returned to their initial values.)
Turn the setting dial or press the UP/DOWN key to display another changed parameter.
● The indication returns to "P.---" when the last changed parameter is displayed.
NOTE
• Calibration parameters (C0 to C7, C38 to C45) are not displayed even when these are changed from the initial settings.
• Only the simple mode parameters are displayed when the simple mode is set (Pr.160 ="9999").
• Only user groups are displayed when user groups are set (Pr.160 = "1").
• Pr.160 is displayed independently of whether the setting value is changed or not.
16. Checking and Clearing of Settings
16.2 List of parameters changed from the initial values
11
12
13
14
15
16
17
18
19
20
399