Omron Sysmac NJ Series User Manual page 58

2 Part Names and Slave Settings
2
Select the connection method for the connection configuration in the Connection type Area.
If you select Remote connection via USB or Ethernet connection via a hub, enter the IP
address of the Controller in the Remote IP Address Area. Also set Options and Response
Monitor Time if necessary. Refer to Setting Items on the Communications Setup Dialog Box
on page 2-8 described later in this manual for information on the settings.
3
Click the OK Button.
This completes the setup.
 Setting Items on the Communications Setup Dialog Box
Item
Connection type
Remote IP Address
Options
Response Monitor
Time
2-8
Specify the connection method to use for online communications.
The specified connection method is used when you go online.
If you select Remote connection via USB or Ethernet connection via a hub, set
the IP address of the Controller that you normally connect to.
USB Communications Test But-
ton
Ethernet Communications Test
Button
Confirm the serial ID when going
online.
Check forced refreshing when go-
ing offline.
You can set the response monitoring time for communications with the Controller.
An error is displayed if a response is not received before this time expires.
Note The time can be set to between 1 and 3,600 s.
NJ/NX-series CPU Unit Built-in EtherCAT Port User's Manual (W505)
Description
These buttons perform a communication test
with the Controller at the specified remote IP
address. The result is displayed as follows:
•
Normal: "Test OK"
•
Error: "The Controller was not found." or
"There is more than one Controller with the
specified IP address."
When going online, the names and serial IDs
are compared between the project and the
Controller to make sure that a connection is
made to the intended Controller.
Before going offline, a check is made to see if
any forced refreshing values are still in effect.