1
Start the Sysmac Studio and go online with the Controller.
2
Double-click EtherCAT under Configurations and Setup on the Multiview Explorer. Or, right-
click EtherCAT under Configurations and Setup and select Edit.
The EtherCAT Tab Page is displayed.
3
Right-click the EtherCAT master that is displayed in the EtherCAT Tab Page and select
Compare and Merge with Actual Network Configuration.
The Compare and Merge with Actual Network Configuration Dialog Box is displayed. The
results of comparing the settings on the Sysmac Studio with the actual network configuration
are displayed in the Comparison results Column.
NJ/NX-series CPU Unit Built-in EtherCAT Port User's Manual (W505)
5 Setting Up EtherCAT Communications with the Sysmac Studio
5
5-29