Omron Sysmac NJ Series User Manual page 210

9 Troubleshooting
 Operation Button Functions
The following table describes the buttons to operate the diagnostic and statistical information.
Button
Get
Clear Master Diagnosis/
Statistics Information
Clear Slave Diagnosis/Statis-
tics Information
Output File
*1. Only for the EtherCAT slaves that are registered in the network configuration information of the project.
*2. This appears only when the unit version set in the Sysmac Studio project is 1.11 or later.
*3. The Viewer Format file is used to review the obtained diagnostic and statistical information in the Ether-
CAT Diagnosis/Statistics Information Viewer on the Sysmac Studio. Refer to Diagnostic and Statistical
Information in the Sysmac Studio Version 1 Operation Manual (Cat. No. W504) for details on the Ether-
CAT Diagnosis/Statistics Information Viewer on the Sysmac Studio. Sysmac Studio version 1.29 or high-
er is required to use the EtherCAT Diagnosis/Statistics Information Viewer.
*4. For a CSV file, if the number of error frames exceeds 255, 255 is output.
9-12
Acquires the diagnostic and statistical information from the EtherCAT master
and EtherCAT slaves
You can retain a maximum of 100 diagnostic and statistical data that you ac-
quired.
When the Display Diagnosis/Statistics Information Tab Page is closed,
the diagnostic and statistical information that you acquired are discarded.
Clears all values of the master diagnostic and statistical information to zeros.
Clears all values of the slave diagnostic and statistical information to zeros.
*2
Outputs the diagnostic and statistical information to a CSV or a Viewer For-
*3
mat file in a specified folder. The following data are output.
•
Master diagnostic and statistical information
•
Slave diagnostic and statistical information
Function
*1
and updates the display.
NJ/NX-series CPU Unit Built-in EtherCAT Port User's Manual (W505)
*4