Omron Sysmac NJ Series User Manual page 119

The EtherCAT slave settings are listed below.
Name
Device name
Model name
Product name
Revision
PDO Communications Cycle
Node Address
NJ/NX-series CPU Unit Built-in EtherCAT Port User's Manual (W505)
5 Setting Up EtherCAT Communications with the Sysmac Studio
Edit-
ing
OK Displays the name of the slave.
Default setting: E*** (where * is a serial number starting from 001)
The default value is automatically generated based on the node ad-
dress.
Not Automatically displays the name of the slave model.
al-
lowed.
Not Displays the product name of the slave.
al-
lowed.
Not Displays the revision of the slave.
al-
lowed.
Not Displays the process data communications cycle assigned for the
*1
al- slave.
lowed. Either of the following values is displayed.
•
PDO Communications Cycle 1
Communications cycle is the task period of the primary periodic
task.
•
PDO Communications Cycle 2
Communications cycle is the task period of the priority-5 periodic
task.
OK Sets the node address.
The default value is set automatically when a slave is added.
Setting range: Settable node address range
Remarks
*2
5
5-21