Ebl-Edge Blending Selection; Edo-Edid Override; Eme-Enable Asynchronous Serial Messages - Christie Crimson Technical Reference

EBL–Edge Blending Selection
Selects the edge blend to use on the projector.
By default, edge blends are not on the projector. Use Twist or Mystique to add edge blends to the
projector.
Commands
Command Description
EBL+SLCT?L Retrieves a list of available edge blends.
(Read-only)
EBL+SLCT <value> Selects the edge blend to use on the
projector. This command is only available if
video electronics are on. (Saved value)
EDO–EDID Override
Configures which EDID is presented using inputs that support EDIDs (such as DisplayPort, HDMI, DVI,
and so on).
Use this command to configure what Crimson advertises regarding the type of signals it accepts. This
command does not need to be set to accept a particular type of signal.
Commands
Command Description
EDO <rate> Defines the expected frame rate regardless of the
active window size of the signal. This command is
only available if video electronics are on. (Saved
value)
EME–Enable Asynchronous Serial Messages
Enables or disables the asynchronous serial messages that the projector occasionally transmits.
Commands
Command Description
EME <0 | 1> Enables or disables asynchronous serial
messages. (Saved value)
Crimson and Crimson Mirage Technical Reference–Serial Commands
020-102660-01 Rev. 1 (07-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Serial API commands
Values
—
0 = Turns off edge blending
1 to 4 = Selects one of the four edge
blends, if available
Values
24
25
30
48
50
60 (Default)
Values
0 = Disables all asynchronous FYI/ERR
serial messages
1 = Enables asynchronous FYI/ERR serial
messages (Default)
24